1. Technical Standards
Use dial indicator or feeler test
(1) on the dial from flatness: Standard ≦ 0.05mm
(2) from the roundness of the dial: Standard ≦ 0.05mm
(3) from the lower cylinder roundness: Standard ≦ 0.05mm
(4) from the lower cylinder Roughness: Standard ≦ 0.05mm
(5) on the dial, the lower cylinder with roundness: Standard ≦ 0.05mm
(6) on the dial, the lower cylinder with roundness: Standard ≦ 0.05mm
(7) on the disc triangle and cylinder gap 0.15mm-0.20mm
(8) under the ring triangle and cylinder gap 0.15mm-0.20mm
2. The primary adjustment
For more safe and efficient use of the machine, in front of the machine using the following checks do first and primary adjustment.
(1) Check the motor drive
After connecting the power, make sure to check the driving direction of the motor, if the direction of the motor drive direction with the motor housing shown in a different label, you must immediately change the wiring of the motor (in the three phases in the motor terminal box two opposite tune it).
(2) Check and adjust the motor drive belt
Before starting the work, check the motor drive belt tension, pressure 1-1.8kg in the middle of the belt, when the belt linear distortion should not exceed 3.5mm, too loose or too tight should immediately adjust until it reaches the requirement. Adjustment as follows: Loosen motor base fixing screws, move the motor outwards or inwards, adjusted to meet the requirements after tension locking screw.
NOTE: Three days after the initial operation, should be reviewed once every three months for a checkup after
Adjustment (3) Dust System
Dust system fan should do specific adjustments, the fan in the best position to rotate after it is powered, can be blown into the yarn in every corner.
Adjustment (4) yarn feed drive system
A yarn feeding aluminum plate spinner
Adjust the feed yarn diameter aluminum disc, you can play fine-tune the transmission ratio, the amount of yarn into the role change, adjustment method is as follows:
Use a wrench to loosen the first yarn feed circular aluminum plate on top of the nut. The upper part of the front cover to the "+" direction of rotation, 12 slide inside the aluminum plate will expand outward, increasing the diameter of the wheel, thereby increasing the amount of feed yarn, on the contrary, to the "-" direction of rotation, the slider inside income, wheel diameter narrowing, into yarn volume will be reduced. The cover should be solid during rotation parallel, otherwise, the slider may fall out from the slot. ® yarn feed adjustable aluminum disc diameter range is:. 70mm-200mm aluminum plate after the adjustment, retighten the round nut. Aluminum plate well after the yarn feed micro adjustment, coping yarn feed belt tension adjustment to do.
B feed yarn tensioning the transmission belt
If the belt is too loose, the thread will slip reservoir stopped, influence into yarn, so to deal with before starting the yarn feed belt make the following adjustments:
Loosen the wheel fixing screws, pull out the roller move along the slider, it should do so on the whole lap belt yarn accumulator force uniform. Screws.
(5) Check grease lubricated
Check the lubrication of the various parts of the transmission and distribution system volume, add grease lubricated every day, avoid mechanical wear and tear caused by the lack of grease.
For more information, please visit knitting machine accessories, circular knitting official website http://www.taisong.net