1. Technical Standards
Use dial indicator or feeler test
(1) on the dial from flatness: Standard ≦ 0.05mm
(2) from the roundness of the dial: Standard ≦ 0.05mm
(3) from the lower cylinder roundness: Standard ≦ 0.05mm
(4) from the lower cylinder Roughness: Standard ≦ 0.05mm
(5) on the dial, the lower cylinder with roundness: Standard ≦ 0.05mm
(6) on the dial, the lower cylinder with roundness: Standard ≦ 0.05mm
(7) on the disc triangle and cylinder gap 0.15mm-0.20mm (8) under the ring triangle and cylinder gap 0.15mm-0.20mm
2. The primary adjustment
For more safe and efficient use of the machine, in front of the machine using the following checks do first and primary adjustment.
(1) Check the motor drive after connected to the power, make sure to check the driving direction of the motor, if the direction of the motor drive direction with the motor housing shown in a different label, you must immediately change the wiring of the motor (motor terminal box will be in The two-phase relative to tune it).
(2) before the motor drive belt inspection and adjustment work boot, check the motor drive belt tension, pressure 1-1.8kg in the middle of the belt, when the belt linear distortion should not exceed 3.5mm, too loose or too tight should immediately adjust the requirements so far until the adjustment method is as follows: Loosen the screws fixing the motor base, move the motor outwards or inwards, adjusted to meet the requirements after tension locking screws can Note: Three days after the initial operation, should be reviewed once after every three months for a checkup
Adjustment (3) Dust System
Dust system fan should do specific adjustments, the fan in the best position to rotate after it is powered, can be blown into the yarn in every corner.
Adjustment (4) yarn feed drive system
A yarn feeding aluminum plate trim adjustments feed yarn diameter aluminum disc, you can play fine-tune the transmission ratio, the amount of yarn into the role change, adjustment method is as follows: First, use a wrench to loosen the yarn feed circular aluminum plate on top of the nut. The upper part of the front cover to the "+" direction of rotation, 12 slide inside the aluminum plate will expand outward, increasing the diameter of the wheel, thereby increasing the amount of feed yarn, on the contrary, to the "-" direction of rotation, the slider inside income, wheel diameter narrowing, into yarn volume will be reduced. The cover should be solid during rotation parallel, otherwise, the slider may fall out from the slot. ® yarn feed adjustable aluminum disc diameter range is:. 70mm-200mm aluminum plate after the adjustment, retighten the round nut. Aluminum plate well after the yarn feed micro adjustment, coping yarn feed belt tension adjustment to do.
B yarn feed drive belt tension adjustment if the drive belt is too loose, the thread will slip reservoir stopped, influence into yarn, so to deal with before starting the yarn feed belt make the following adjustments: Loosen the wheel fixing screws, the roller along the slider to outer-pull, this should be done on the whole of the belt loop of yarn accumulator force uniform. screws.
(5) Check grease lubricated
Check the lubrication of the various parts of the transmission and distribution system volume, add grease lubricated every day, avoid mechanical wear and tear caused by the lack of grease.
Circular knitting machine, knitting machine accessories http://www.taisong.net